Readers ask: Motorcycle Shuts Off When Throttle?

Why is my dirt bike dying when I give it gas?

Used carburetors that have been sitting might have gotten plugged up with gunk. If that gunk is blocking the main jet and/or partially blocking the fuel flowing into the float bowl, that could cause the problem you are describing. Sounds like a vacuum leak or too lean carb settings.

Why does my motorcycle die when I give it throttle?

False Idles Rich bikes are getting too much gas, so they idle high but lose power when given initial throttle because they can ‘t burn all the gas. Lean running engines tend to “hang up” at high rpms when the throttle is let go, and they also rev down slowly after the throttle is closed.

Why my bike suddenly shut down?

I would do the obvious first, check the fuel vent for the gas tank, change the fuel filter, make sure your grounds and leads are tight, look at your connections @ the ign switch if possible and check all the fuses they don’t always blow clean sometimes connection is an issue. Then try the more specific stuff.

Why does my motorcycle sputter when I give it gas?

There are several reasons why a motorcycle sputters. The most common reasons are carburetor issues such as a vacuum leak, fuel leak, or tuning issues. Other culprits could include corroded or cracked spark plugs or spark plug wires, a faulty ignition coil, a clogged air filter, or engine timing issues.

Why does my scooter dies when I give it gas?

This can be caused by a faulty petcock (or vacuum leak), bad hoses, clogged fuel filter, stuck float, any of which could also be exasperated by low quality gas.

Can a completely dead motorcycle battery be recharged?

If you do have a dead battery, you can recharge it with a battery charger (this is preferred), or by jumpstarting your bike with another bike or a car. Once you get the bike running, make sure to ride it for a good while in order to get it fully charged again.

Why does my engine die when I give it gas?

A dirty carburetor or something is restricting fuel flow. When you hit the gas pedal, the throttle plate opens, allowing a lot of air in, the engine vacuum plunges, and without an increase in the amount of fuel, the fuel -air mixture is simply too lean for the engine to continue running.

Why do Harley riders rev their engines?

Of course, unoptimized lubrication, especially in something as delicate as an engine, can result in premature wear, or worse, engine failure. Perhaps the reason motorcycle riders of today still incessantly rev their motors at a stoplight—to the annoyance of non enthusiasts— is simply because it feels and sounds cool.

How do you tell if a carburetor is rich or lean?

If the insulator near the plug tip is a nice light tan colour then it’s running approximately correct at that load/rpm. If they’re white then it’s running lean, if they’re a dark brown or worse colour then it’s running rich.

What to do if bike is not starting?

What to Do When Your Motorcycle Won’t Start (But the Battery is Good)

1. Confirm There’s Gas in the Tank.
2. Engage the Clutch.
3. Put the Motorcycle in (the Right) Gear.
4. Look for Loose Wires.
5. Confirm the Kill Switch is Off.
6. Ensure the Fuel Valve is Set to “On”
7. See if the Fuel Injection System is Functional.

What causes a motorcycle to stall?

A stall happens when there is insufficient power being fed from the engine to the rear wheel to get it moving or keep your bike rolling. Once you’re moving it’s all about balancing the usable revs of the engine with your bike’s speed, and remembering to pull in the clutch when you come to a stop!

Why does my motorcycle engine stop when riding?

If while you were riding you noticed unusual noises coming from your engine, and your engine temperature is running hot, then chances are your oil level is down. Another common reason with motorcycles that stop running is electrical. And the most common of electrical problems is simple: a fuse that has blown.

Can bad spark plugs cause sputtering?

Dirty or bad spark plugs won’t cleanly ignite the fuel causing the vehicle to misfire or sputter. You’ll either need to replace or have them cleaned. Because engine sputtering is a symptom of something more serious, it’s important to rely on an experienced mechanic to diagnose and repair the problem.

What causes engine hesitation on acceleration?

A vehicle that hesitates while accelerating or while driving up a hill may have a weak fuel pump. Fuel injectors may become dirty over time and not be able to provide as much fuel to the cylinder as is needed. Dirty fuel injectors may cause the engine to run lean which will in turn, cause hesitation when accelerating.

Why does my motorcycle sputter and backfire?

A motorcycle backfire is caused by a mismanaged air to fuel ratio in the engine of your motorcycle. If you don’t do this step, you’re motorcycle is more likely to sputter and backfire with the custom exhaust system. Another cause for motorcycle backfires is a bad fuel pump.